Does your Tampa, FL Business Need Board-Up Services?

1/11/2022 (Permalink)

SERVPRO of Greater Carrollwood/ Citrus Park can assist with board-up services. Call today!

If your home or business was affected by storm or fire damage that results in an opening in your building, you might need emergency board-up services. Any opening in the structure needs to be boarded appropriately to protect the building from the weather and illegal entry. Your insurance policy also requires you to be proactive in protecting your home or business after any damage has occurred. Otherwise, the insurance company could account for any further/secondary damage to the structure as negligence.

Not every situation requires the most extensive board-up that the U.S Fire Administration has in their board-up procedure manual, such as after a fire where the entire home is destroyed and is considered a complete loss. While each emergency board up is different, SERVPRO of Greater Carrollwood/ Citrus Park is here to help.  

Let's take a look at how to properly board up a structure after the damage has caused an opening in the building.

Determining How Much Protection is Needed

1. Openings in the basement, first floor doors, windows, and any entry point accessible from a porch, fire escape, or other potential climbing points require additional security measures. Openings should be barricaded with plywood, 2x4s, bolts, and nails.
2. Openings at least 10′ from ground level, which is not accessible from a porch, fire escape, roof, or other climbing points, can be secured with nails in each brace and every 12″ around the perimeter. The plywood should be fitted for these openings so that it rests snugly against the exterior frame, butting up to the siding on wood frame buildings and up to the brickwork on brick buildings. It may be necessary to remove the staff bead so that this fit can be flush and tight.

Board-Up

1. Cut plywood to fit over the window and door openings, flush with the outside of the molding.
   Note: For buildings with a metal door and window frames, the alternative is to cut the plywood and 2x4s to fit the door frame inside buffed up against the band molding.
2. Cut the 2x4s to fit the horizontal dimension of the plywood. You will need two 2×4 exterior and two interior braces for each window and three sets for each door.
   Note: For buildings with metal doors and window frames, the 2x4s for the outside will be cut to the plywood dimensions, fitting inside the door frame, against the band molding. The 2x4s will be cut to the outside dimension of the door or window frame for the inside.
3. Next, pre-drill 3/8th inch holes in the plywood and the braces.
4. The holes will be placed approximately 1/3 of the brace's length from each outside edge of the door and window jam.
5. The two window braces will be placed 1/3 of the distance from the top and the bottom of the window.
6. The three-door braces will be placed; one in the center of the doorway and one half the center's distance to the top and the bottom of the doorway.
7. Place the plywood over the exterior opening and nail it to the frame.
   Note: For metal frames, place the plywood and braces inside the frame against the band molding.
8. Place the 2×4 braces over the interior and exterior of the door or window.
9. Place the large washer over the carriage bolt and place the bolt through the holes.
10. Place the washer and nut inside and tighten securely. Torque the nut so that it slightly compresses the interior 2×4.

Did you know SERVPRO of Greater Carrollwood/ Citrus Park provides emergency board-up services? Let us mark a big task off of your to-do list when preparing for a storm. We understand the anxiety when it comes to managing a business during storm watches and warnings. We are here to help. Call us anytime at (813) 694-9085.